ACTi KCM-3911 - Manual (Page 17)

www.acti.com
KCM-3911 Hardware Manual
17
Mounting on the Ceiling or Wall with the Base Plate
Use the bundled base plate to mount the camera flat on the ceiling or the wall.
CAUTION: Do not mount the camera directly to the surface without a base plate.
Step 1: Install the Base Plate
IMPORTANT!
Before drilling the holes on the ceiling or wall, note the camera placement and where you
should drill the hole where the cables will pass through or how the cable will go along the
ceiling or wall.
For wall installations , the connectors side must face up to install the camera with a correct
orientation.
1. After considering the orientation direction, drill the three (3) holes on the ceiling or wall
using the drill template or the base plate itself as the template. If the cables will pass
through the ceiling or wall, drill also the cable hole at this point.
Screw hole
Camera Connectors Side
Base Plate
Connectors Side