Step 2: install the heavy duty mount, Optional: add extension tube(s) – ACTi Indoor PTZ on Straight Wall with Accessory Sets of PMAX-0305 User Manual

Page 5

Installation Guide

Step 2: Install the Heavy Duty Mount

There are two ways to route the cable from the network side:



Pass through a hole on the wall and through the Heavy Duty Mount.



Go along the wall and go through the conduit hole on the bottom of the Heavy Duty

Mount.

Insert the network cable and other cables (if any) through the Heavy Duty Mount.

Cable Passing Through the Wall

Cable Going Along the Wall

NOTE:

Other cables refer to cables of an external power adapter, audio input/output and

digital input/output devices.

Attach the Heavy Duty Mount on the wall using four (4) screws (not included in the package).

Optional: Add Extension Tube(s)

If the Heavy Duty Mount is not long enough, add one extension tube (purchased separately). See

on page 9.