ACTi Indoor Dome (B6x) on Tilted Wall - Manual (Page 6)

www.acti.com
Installation Guide
6
Step 4: Connect the Cable(s)
1. Connect the network cable to the Ethernet port of the camera.
If necessary, connect other cable connectors (optional), like audio input/output, DC 12V
power, and DI/DO to the corresponding connectors on the camera.
Refer to the following sections for detailed information on how to connect other devices:

How to Connect the Power Adapter (Optional) on page 17

How to Connect DI/DO Devices (Optional) on page 19

How to Connect Audio Devices (Optional) on page 22
2. Connect the other end of the network cable to a switch or injector. Then, connect the switch
or injector to a network or PC and a power source. See Power-over-Ethernet (PoE)
connection example below.
Network
AC Power
Source
PoE Injector /
PoE Switch
Power Cable
Ethernet Cable
Ethernet Cable
(Data + Power)
Ethernet Cable
(Data)
Camera
In case of using a non-PoE switch, power up the camera using a power adapter (not supplied).
As needed, power up the other connected devices.
Ethernet Port
Digital Input / Output
(DI/DO) Connector
Audio Input / Output
Connector
12V Power Connector