Xoro HRS 8540 - Manual (Page 11)

10/31
4. Installation
Please connect all cable before powering on your product for the first time after
purchase.
Tip: The default password is 0000.
4.1 Powering On
1. Connect the power cord of the product to a wall outlet.
2. Ensure the ON/OFF switch at the rear of the product is switched to ON.
3. Power on by pressing the STANDBY button on the remote control or the
STANDBY button at the front of the product.
4.2 Antenna Connection
Antenna Connection allows you to configure the antenna using only one LNB or
Motor.
Menu->Installation->Antenna Connection
When select Motor Antenna here, you can set the DiSEqC1.2 or Motor in
Antenna Setup.
4.3 Antenna Setup
Antenna Setup allows you to configure the antenna setting parameters.
Menu->Installation->Antenna Settings
1. Satellite: Select the satellite you want to configure.
2. LNB Freq: Press the VOL+/VOL-
button to change the LNB
frequency.
3. Transponder(TP for short):
Press the VOL+/VOL- button to
change the TP.
4. DiSEqC 1.0: Press the
VOL+/VOL- button to select the
required DiSEqC1.0 input.