Eiki LC-XS25 - Manual (Page 52)

52
Setting
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary
code (Code 2). This switching function prevents remote
control interference when operating several projectors or
video equipment at the same time.
When operating the projector in "Code 2", both the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Remote control
Press and hold
M E N U a n d
IMAGE buttons
for more than 5
seconds.

Note:
If the batteries are removed from the remote control
for a long period of time, the remote control code will
be reset.
Filter control
You can replace the filter with this function. Press the
SELECT button at Filter control to display a confi rmation
box. To replace, press the SELECT button at “YES” and
the electrically operated fi lter starts to scroll.
Note:
• F i l t e r r e p l a c e m e n t i c o n a n d “ P l e a s e w a i t . . . ”
message appear on the screen when the filter
is being scrolled.
• The fi lter cannot be rewound.
• When the filter is replaced, the total accumulatedtime
of the fi lter use is automatically set to 0.
Filter control
Move the red frame pointer to
" f i l t e r c o n t r o l " a n d p r e s s t h e
SELECT button.