Electrolux 86000 i - Manual (Page 23)

An accumulation of dust will affect
the performance of the appliance and
cause excessive electricity consump-
tion. The structure of the appliance
permits you to clean the rear zone
close to the wall, using a vacuum
cleaner.
☞
1. Remove the plinth (1), then the venti-
lation grid (2);
2. Carefully pull the air deflector out (3),
checking that there is no water left from the defrosting.
3 2 1
Energy Saving Tips
• Do not install the appliance near boilers, radiators or other sources
of heat. High ambient temperatures cause longer, more frequent
operation of the compressor.
• Ensure sufficient air circulation and exhaust at the appliance base
and at the back wall of the appliance. Never cover air vent openings.
• Do not place warm foods into the appliance. Allow warm foods to
cool first.
• Do not leave the door open any longer than necessary.
• Do not set temperature any colder than necessary.
• Put frozen food in the fridge to defrost. The cold in the frozen food
will then be used to cool the fridge.
What to do if ...
Correcting Malfunctions
A malfunction may be caused by only a minor fault that you can recti-
fy yourself using the following instructions. Do not perform any other
work on the appliance if the following information does not provide
assistance in your specific case.
Important! Repairs to refrigerators/freezers may only be performed by
competent service engineers. Improper repairs can give rise to signifi-
cant hazards for the user. If your appliance needs repairing, please
contact your specialist dealer or your local Service Force Centre.
23