Widex C2-PA (RIC) - Manual (Page 27)

27
The anchor can also be trimmed to fit your ear:
Pull the pointed end of the anchor
through the upper hole on the receiv-
er located at the end of the earwire.
The angled grip should be pointing
towards the device.
Continue pulling until the anchor is stopped by the grip
at the end. Now turn the ear-set around.
Then guide the pointed end of the an-
chor through the lower hole to form a
loop.
When the loop is the correct size, cut
any excess off, leaving only the loop.
The anchor loop has the correct size when
it supports the position of the ear-tip in
the ear canal, and the ear-set sits secure-
ly in and on the ear.