Westermo MRD-330 - Manual (Page 21)

21 6623-2211
• The Status summary page will be displayed, it will be similar to figure 6.
Figure 6
Note: If the unit is not yet configured it is likely that the Network Status and
Connection Status will indicate a fault condition.
Basic Configuration
The three sections below detail the steps needed to configure the MRD-330 for basic
packet mode functionality. For details on how to configure the unit for Circuit Switched
mode and for more advanced configuration refer to the Advanced Configuration section
of the Reference Guide.
Configure the 3G Wireless interface
To access the configuration page for the 3G Wireless interface, click on Wireless.
The Basic Wireless configuration page will be displayed as shown in figure 7.
Figure 7