Westermo ED-20 - Manual (Page 12)

12 6609-2222
6.3. Settings
6.3.1. Channel 1 serial interface
Settings of the Ethernet Router are made with DIP switches and with ED-Tool for ED-20
(Windows based configuration software).
6.3.1.1. DIP Switch Settings
DIP-switches are accessible under the lid on top of the unit. DIP-switches are used to
set-up the serial port.
Warning!
Prevent damage to internal electronics from electrostatic discharges (ESD) by
discharging your body to a grounding point (e.g. use of wrist strap), before the
lid on top of the unit is removed.
Warning! Do not open connected equipment.
Prevent access to hazardous voltages by disconnecting the unit from AC/DC
mains supply and all other electrical connections.
NOTE! Always reboot the unit after any changes
of the DIP-switches has been made.
!
!