Westermo ED-10 TCP - Manual (Page 20)

20 6609-2211
Program Start:
To start ED-Tool
• Locate ED-Tool under Program on the Windows Start Menu.
• Click on the ED-Tool icon
• Or locate the ED-Tool icon on the desktop
After the ED-Tool has been successful opened the user is presented with an empty
configuration screen.The user can now get an existing configuration by reading the
configuration from an ED-10 TCP or by opening a configuration file stored on the
system. Or the user can set all configuration parameters by hand.
To configure an ED-10 TCP the user must set all parameters. After the parameters are
set the user can write the configuration to the ED-10 TCP.
Typical configuration procedures:
• Read configuration from an ED-10 TCP
• Change some parameters
• Write configuration to the ED-10 TCP
• Reboot
• Done
or
• Read configuration from a file
• (Change some parameters)
• Write configuration to the ED-10 TCP
• Reboot
• Done
or
• Select the ED-10 TCP property tab
• Set parameters
• Write configuration to the ED-10 TCP
• Reboot
• Done
or
• Select the ED-10 TCP property tab
• Set parameters
• Save configuration to a file
• Done