Westermo DR-250 - Manual (Page 16)

16 6622-2211
Configuration by Web Tool
The DR-250 includes an easy-to-use Web configuration tool. The Web tool is very
intuitive and includes useful help information for the configurable parameters.
Connect and login to the DR-250 on the default IP address and with default username
and password combination (or your customized if configured) using a standard Web
browser.
Basic ADSL setup
The following must be done to get basic ADSL connectivity. There are two different ways
that are used to get a ADSL connection. This depends on what your ADSL provider uses.
PPP over Ethernet or PPP over ATM (PPPoE, PPPoA)
Username and password is supplied by your ADSL provider.
ADSL Interface
Choose the correct encapsulation PPPoE or PPPoA
PPP Account
Username: Supplied by your ADSL operator
Password: Supplied by your ADSL operator
Press Save then press OK
Press Reboot then press Reboot
After the reboot the Router will connect over ADSL and the LED DSL should flash
green.
Bridged Ethernet
ADSL Interface
Set Encapsulation method to Bridged Ethernet VC-Mux or Bridged Ethernet LLC.
(Check service provide details for correct setting)
Set VPI and VCI to match the values supplied by the ADSL service provide.
• ETH4 Bridged ADSL
Set DHCP client to Enabled
Set NAT Mode to NAT
• Default route 0
Set Interface to Ethernet
Set Interface #: to 4
The Source Mask (255.255.255.0) should be removed
Press Save then press OK
Press Reboot then press Reboot
After the reboot the Router will connect over ADSL and the LED DSL should flash
green.