Westermo DDW-221 - Manual (Page 14)

14 6642-22102
Configuration
The unit can easily be configured via the onboard Web based configuration tool. Local
IP addresses can also be configured by using the Westermo IP Config too. From the IP
Config tool it is then possible to browse into the unit for further configuration.
IP Address
When delivered, the default IP address of the DDW-2XX is 192.168.2.200.
The default gateway is 192.168.2.200
If the default address of the unit is valid in the connected network it is possible to access
the unit directly from a web browser.
Change local IP address
The local address of DDW-2XX can be configured using the IP Configuration tool.
The IP Configuration program is available on the CD or for download from the
WESTERMO web page: http://www.westermo.com, (choose Downloads/Software/
Ethernet/Ethernet switches/)
Name: setup.exe
Install the software and start the application from a PC on the network connected to
where the DDW-2XX is installed. Make sure that the Default IP of the configuration soft-
ware (see figure below) is in the same subnet as your PC.
Note! If you are not sure about the subnet – consult your network administrator.
Note! IP Config version must be 10.0.0 or higher.
Figure 1
Help About
Scan for switches Close
Default IP:
Device list:
IP Adress Subnet Mask MAC Adress SW Ver Type Status
192. 168. 2. 60
192.168.2.200 255.255.255.0 00-07-7C-80-4A-6C 9.74 DDW-221
Mask: 255. 255. 255. 0
IP configuration
Note! If you are not
sure about the settings
- consult your network
administrator.