Westermo ED-2x0 - Manual (Page 10)

10 6609-2281
Diagnostic information
Restore Factory default settings
Under the lid there is a reset push button.
This will clear your customized settings and
restore the factory default settings.
Note! Do not disconnect power during the
factory reset process.
The process takes 90 second to complete if
the default address of the unit is valid on the connected network it is possible to access
the unit directly from a browser.
Simple Network Management Protocol (SNMP)
ED-200 and ED-210 supports Simple Network Management Protocol version 2c
(SNMPv2c). SNMP is an Internet standard protocol (IP) developed to manage IP nodes
(servers, workstations, routers, switches and hubs etc.) on an Ethernet network.
SNMP enables network administrators and controls engineers to manage network
performance, find and solve network problems, and plan for network growth.
The Lynx MIB’s are divided into groups allowing the SNMP manager to poll the SNMP
agents for information. The parts of the following MIB groups are implemented and can
be found on CD.
… General MIB … MIB-2
Location of Interface ports, LED’s and DIP-switches
LED indicators
LED Status Description
RD Flashing Receiving data from WAN port
OFF –
TD Flashing Transmitting data to WAN port
OFF –
PWR ON-green Start up ready
ON-yellow Booting
Flashing green Connected with IPconfig tool.
OFF No power
STAT ON-green Start up ready
ON-yellow Indicating active alarm
OFF –
PPP ON PPP-link established
OFF –
Port 1–4 ON-green Link active
Flashing-green Traffic on link
ON-yellow Indicating alarm
OFF –