Edelbrock 2166 User Manual
Page 4
Catalog #2166, #3766, #7166, #7566
Rev. 3/05 - RS/mc
©2005 Edelbrock Corporation
Brochure #63-0296
Page 4 of 4
INSTALLATION INSTRUCTIONS
1) Use only recommended intake gaskets set when installing
this intake manifold. For ease of installation, we
recommend Edelbrock Intake Manifold Bolt & Washer Kit
#8569.
2) Fully clean the cylinder head intake flanges and the engine
block end seal surfaces.
3) Apply Edelbrock Gasgacinch sealant P/N 9300 to both
cylinder head flanges and to the cylinder head side of the
gaskets, allow to air dry, and attach the intake gaskets.
Figure 1 - 429/460 Ford Torque Sequence
Torque Bolts to 25 ft/lbs.
Firing Order: 1-5-4-2-6-3-7-8
Turn Distributor Clockwise to Advance Ignition Timing
7
4
14
16 8
2
1
15
3
8
7
6
5
4
2
1
3
4) Do not use cork or rubber end seals. Use RTV silicone
sealer instead. Apply a ¼" high bead across each block
end seal surface, overlapping the intake gasket at the four
corners. This method will eliminate end seal slippage.
5) Install the intake manifold and hold-down bolts. Torque all
of the manifold bolts in two steps by the sequence shown
in Figure 1 to 25 ft/lbs.
13
5
11
10
12
6
9
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 800-416-8628 • E-Mail: [email protected]
EGR Adapter Plate
(Supplied)
EGR Adapter Gasket
(Supplied)
Intake Manifold
Front
Figure 2 - EGR Adapter Plate Installation (3766 Intake Manifold)
Install OEM EGR Spacer and Gasket on Top of Edelbrock Adapter Plate