WattMaster WCC III part 3 - Manual (Page 4)

2. INITIATING THE SYSTEM
WCC III Technical Guide 2-2
WCC III Installation Software -
DM1WC011-01X
Please note: Your user name must have
suffi cient rights to install these WCC III programs
onto your computer’s hard drive.
Step 1: Insert the WCC III Program Setup CD (DM1WC011-
01X) into your computer’s CDROM/DVD drive.
Step 2: This disk should “autorun” and start the installation
process and then display the WCC III Program Setup and Option
Selection Screen. The WCC III Program Setup and Option
Selection Screen will allow you to select the installation or removal
of the various WCC III component programs on to the WCC III
Front end computer’s hard drive.
Step 3: Choose either “Select Components to Install” and left-
click the button to continue with the WCC III program
installation or choose “Select Components to Remove” and left-
click the
button to continue with the WCC III program
removal process.
The button will take you back one screen and the
button will allow you to cancel the WCC III Program
Setup installation.
The instructions that follow describe the installation process. The
removal process closely follows the installation procedure, but
instead of installing the various WCC III component programs, it
will uninstall them.
Step 4: Using your left mouse button, select the desired check
boxes to the left of the programs you wish to install and then left-
click the
button to continue with the installation of these
program(s) onto the WCC III Front end computer’s hard drive.
Step 5: The screen will ask you to click the button to
begin installation. After again verifying that you really want to
install these WCC III programs, please left-click the
button.
The button will take you back one screen and the
button will allow you to cancel the WCC III Program
Setup installation.
Full WCC3 Installation