Verilink SNMP Management (No Part Number) Product Manual - Manual (Page 5)

SNMP Management
Verilink SNMP
SNMP-5
DS1 MIB Interface Tables 4 through 10 list the various MIB-II interface parameters.
The accompanying comments explain the parameters, describe
specific conditions, or specify which parameters are not supported.
DS1 Near End
Group
Table 4 DS1 Near End Group 1
Object-Type Parameters
dsx1LineIndex A number calculated with the formula in Calculating
the
SNMP ifIndex
, on page 2.
dsx1IfIndex A unique number.
dsx1TimeElapsed The number of seconds that have elapsed since the
beginning of the current error-measurement period.
dsx1ValidIntervals The number of previous intervals for which valid
data was collected. The value is 96 unless the
interface was brought on-line within the last 24
hours, in which case the value will be the number of
complete 15 minute intervals the interface has been
online.
dsx1LineType Access is read-only and applies to network side.
other(1) for any line type not defined in this object.
dsx1ESF(2) for ESF framing.
dsx1D4(3) for D4 framing.
dsx1E1(4) for G.704 framing (Table 4a).
dsx1E1_CRC(5) for G.704 framing (Table 4b).
dsx1E1_MF(6) for G.704 framing with TS16
multiframing enabled (Table 4a).
dsx1E1_MF(7) for G.704 framing with TS16
multiframing enabled (Table 4b).
dsx1LineCoding Access is read-only and applies to network side.
dsx1B8ZS(2) for B8ZS line coding.
dsx1HDB3(3) for HDB3 line coding.
dsx1AMI(5) for AMI line coding.
other(6) for any line coding not defined in this
object.
dsx1SendCode Access is read-write:
• dsx1SendNoCode(1) if no test pattern is sent.
• dsx1SendQRS(5) if near end is sending QRSS test pattern.
• dsx1Send3in24Pattern(7) if near end is sending 3/24 test
pattern.
For “read”:
• dsx1SendOtherTestPattern(8) if sending a test pattern other
than those defined in this object.
For “write”:
• dsx1SendOtherTestPattern(8) sends a 1-in-8 test pattern.
dsx1CircuitIdentifier Access is read-write.
Circuit name.