Tri Tool SQM-1AC Squaring Module - Manual (Page 10)

10
TRI TOOL INC.
92-0675 : Rev. 970314
WARNING:
OPERATION
PREPARE THE MACHINE
Read the operating instructions carefully before attempting to operate the Model
SQM-1AC Squaring Module.
Refer to the Operator’s Manual for operating instructions for the Model 572AC
SEVERMASTER
TM .
The use of dull or improperly designed tool bits or tool bits not manufactured
by TRI TOOL Inc. may result in poor performance and may constitute abuse
of this machine and therefore voids the TRI TOOL Inc. factory warranty.
Remove the shaft assembly by rotating the adjustment lever.
Tighten the shaft assembly onto the face of the Model 572AC.
Mount the Squaring Module onto the shaft assembly and tighten the adjustment
lever.
Loosen the (3) three set screws to let the tool bit slide.