Datalogic Scanning Modem User Manual
Page 19
DATALOGIC
11
UK/US
SET RADIO ADDRESSES
Follow the procedure below to set the STAR
Modem™ radio address and prepare it
to receive and transmit data to all devices included in the range from the First to the
Last STAR-System™ destination device.
1.
Enter Configuration
$+
2.
Set STAR
Modem™ Radio Address
xxxx = four digits for the STAR
Modem™ address (from
0000 to 1999). This address must be unique.
MA1RCxxxx
3.
First STAR-System™ Destination Device Address
xxxx = four digits for the Destination Device address (from
0000 to 1999).
MSxxxx
4.
Last STAR-System™ Destination Device Address
xxxx = four digits for the Destination Device address (from
0000 to 1999).
If transmitting to one Destination device only, this selection
is not required.
MTxxxx
5.
Set RF Baud Rate (not for USA model)
x = 0 defines 9600 baud
1 defines 19200 baud
MFx
6.
Exit and Save Configuration
$-CR
When defining a range of destination device addresses, STAR
Modem™ activates
roaming towards all the devices included within this range.
No interface selection is required, since all STAR-System™ transactions occur via
serial interface.