Tri Tool 620SB Clamshell Air - Manual (Page 23)

23
Model 620SB Low Profile Clamshell, Air
92-0220 : Rev. 131230
NOTE:
WARNING:
CAUTION:
If the Feed Pin to Sprocket engagement is not as shown, operation of the
Clamshell may cause serious damage or destroy the Feed Pin and/or the
Sprocket.
If the Feed Pin to Sprocket engagement is as shown in ‘Incorrect alignment of the
Correct Alignment of the Feed Pin Feed Pin Positioning
CAP SCREWS
Correct Alignment of the Feed Pin Feed Pin Positioning
Feed Pin’, then it will be necessary to loosen the four (4) Cap Screws on the Tripper
Bracket, so that it may be adjusted to the proper gap (.020” to .030” or .51 mm to
.76 mm) required for proper engagement.
Go to ‘General machining sequence’ earlier in this section.
TOOL BIT SET-UP
Select the proper Tool Bit set. Refer to ‘Tool Bits’ later in this booklet.
The use of dull or improperly designed Tool Bits or Tool Bits not manufactured
by TRI TOOL Inc. may result in poor performance and may constitute abuse
of this machine and therefore voids the TRI TOOL Inc. factory warranty.
Install the Tool Bits into the Tool Holders.
Refer to ‘Tool Bits’ for installation drawings of each Tool Bit set-up.