Tri Tool 304 Collet Adapter Kit - Manual (Page 14)

14
TRI TOOL INC.
92-0776 : Orig. 980903
Problem: The tool bit will not reach the work
Probable causes:
Incorrect tool blocks are installed for the size of the pipe or tube being worked on.
Incorrect tool bit is installed.
Problem: The tool holder is not feeding
Probable causes:
The feed pin is broken or out of position.
The feed sprocket shear pin is broken.
The feed screw is stripped.
The feed nut is stripped.
The slide rails are too tight.
Problem: There is a loss of air power
Probable causes:
The air supply pressure is too low.
The air filter is plugged.
The air line size is insufficient.
The air line is too long.
Problem: There is a loss of hydraulic power
Probable causes:
The hydraulic supply pressure is too low.
The hydraulic filter is plugged.
The hydraulic line size is insufficient.
The hydraulic line is too long.
Problem: The hydraulic motor will not start
Probable causes:
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.
Problem: The air motor will not start.
Probable causes:
The air power is shut off.
The air motor is damaged and will not run free.
The air motor needs lubrication. Add lubrication and do not run the air motor for a few
minutes, then try running the motor.
Tap on the side of the air motor casing lightly with a piece of wood or with a soft rubber
mallet just in case the veins may be sticking.
Sand or other foreign material may be in the veins of the air motor.