Tri Tool 302 Tube Squaring - Manual (Page 18)

18
TRI TOOL INC.
92-0547 : Rev. 140610
Rotate the feed knob counterclockwise to separate the cutting head and the tube or
pipe.
Stop the tool rotation.
Release the trigger on the motor.
Rotate the feed knob counterclockwise until the cutting head clears the tube or pipe
by at least 1/8” (3 mm) or more.
Loosen the upper saddle to release the tube or pipe.
Rotating the Feed Knob
Discontinue feed and allow the cutting head to rotate one (1) to three (3) revolutions
to improve the finish of the prep surface.
Feed Knob
Tube or Pipe Cover