Tri Tool 214B Miter Mandrel Head Kit - Manual (Page 17)

17
Model 214B MM (Miter Mandrel)
92-1505 : Orig. 100923
MAINTENANCE
Tri Tool Miter Mandrels are precision tools that will perform excellently if they are
well maintained.
Keep the Miter Mandrel clean.
Brush away any chips or other debris with a soft bristle brush.
Wipe the Miter Mandrel down with a lightly oiled rag.
Inspect the Miter Mandrel before each use. Check for stripped threads, burred,
worn, or missing parts, and replace as necessary.
Occasionally back off the Miter Head and remove it from the Miter Mandrel.
Check all parts for cracks, burrs, etc.
Maintenance of the Miter Mandrel
Remove the (4) four Angular Offset Adjusting Screws.
Check the spherical bearing surface for burrs and/or other defects.
Do not reuse any parts that show evidence of cracking, bending or over stressing.
Apply a very thin film of general-purpose grease or anti-seize to the spherical sur-
face.
Oil all of the Screws and threads, and reassemble in the reverse order of them
being disassembled.
Miter Head
Angular Offset adjustment Screws
Mandrel Shaft
Jackscrews