Tri Tool 214B Miter Mandrel Head Kit - Manual (Page 11)

11
Model 214B MM (Miter Mandrel)
92-1505 : Orig. 100923
NOTE:
All four (4) of the Angular Offset Adjustment Screws must be used in con-
junction with each other and all of the Screws must be slightly tight to allow
movement.
If the Mandrel Shaft is to be drawn directly toward one Screw, this Screw must be
loosened far enough to allow for take up before the near screw is tightened.
Using a tape measure or a steel rule, keep the rear flange of the Miter Mandrel
roughly centered while turning the Jackscrews to tighten them against the ID of the
workpiece.
Use the Wrenches provided to tighten all (4) four Jackscrews securely.
In larger size workpieces, the use of the Jam Nuts should be used for more
stability.
Jam Nut Usage
Mount the Indicator Kit onto the Mandrel and tighten the Thumb Screws.
If the existing surface of the workpiece is going to be used for alignment and center-
ing references, use the Dial Indicator and hardware provided.
If punch marks, scribe lines, or other references are to be used, simply select the
required hardware from the Indicator Kit to be used as a pointer.
Jam Nut
Manderal Shaft
Parallel with the Finish Prep
Jackscrew