Tri Tool 208B Miter Mandrel - Manual (Page 11)

11
Model 208B MM (Miter Mandrel)
92-1497 : Orig. 100728
ANGULAR (SQUARE) ADJUSTMENTS
Changing the angular offset will always change the parallel offset, but changing the
parallel offset will not change the angular offset.
All (4) four of the Angular Offset Adjustment Screws must be used in conjunction
with each other.
To move the Mandrel Shaft in a given direction the Adjustment Screws in the oppo-
site direction of movement must be loosened enough also to allow the amount of
movement anticipated.
Next the Angular Offset Adjustment Screws directly across must be tightened to
draw the Mandrel Shaft in the desired direction.
Never exceed 40 ft/lbs. (54 N m) of torque on the angular offset Adjustment
Screws.
Evenly torque all four (4) Angular Offset Adjustment Screws.
Indicator Sleeve
Assembly
Thumbscrew
Dial Indicator Kit
Dial Indicator Kit
Pointer Rod