Tissot 120 - Manual (Page 7)

Navigator 3000
*
www.tissot.ch 120_EN / 01.06 7/7
Your watch has a timer function. Once the programmed period of time has
elapsed, an audible alarm is triggered.
To stop the alarm, press the crown briefly.
Touch the screen to select the “TIMER“
mode or the “SET“ function.
Press the crown to activate or stop the
timing operation displayed or select the
“SET“ function and press the crown to
set the timer.
Set the hour, minutes and seconds
by means of the tactile zone or .
Confirm each setting by pressing
the crown. After confirming the last
setting (the seconds setting), the
timer is activated automatically.
A further press on the crown stops
timing.
Note: The last time set remains displayed by default 5 seconds before the
timing ends, and a beep sounds for each remaining second.
Your watch has a calendar function available on the digital display, with
3 modes:
• day/date
• second/date
• week number.
Touch the screen to select the desired
display or to navigate through to the
“SET“ function.
To access the settings, select the “SET“
function and press the crown.
Touch the screen several
times until you reach the
setting you wish to change,
then press the crown to
confirm your choice.
Note: Your watch being set in factory, there is no need to correct the date
Reminder: It is possible to change the language (see Time function).
Set the year by means of the tactile
zone or .
Confirm by pressing the crown.
Set the month and day by means of the
tactile zone or .
Confirm by pressing the crown.
Date setting
Select the month/day or day/month
order of display by means of the tactile
zone or .
Confirm by pressing the crown.
Day/Month order of display
Exit setting mode.
We would advise you to clean your watch regularly (except for
the leather strap) using a soft cloth and warm soapy water.
After immersion in salty water, rinse it in fresh water and leave
it to dry completely. Do not leave it anywhere where it might
be subjected to major variations in temperature or humidity, in
direct sunlight or near strong magnetic fields.
To benefit from the highest standards of service and to ensure
your guarantee remains in force, please always contact an
approved TISSOT® representative or retailer.
TISSOT® Quartz watches benefit from the incomparable
precision of quartz. Their power reserve usually enables them
to operate for more than 2 years in continuous use. If you ever
plan not to be wearing your watch for a period of several weeks,
or even several months, we would advise you to activate the
"economy" mode before putting your watch away. This reduces
the electrical power supply to the motors, thereby extending
battery life considerably.
Replacing the battery
Once the battery has run flat, it must be replaced without delay
by an approved TISSOT ® representative or retailer.
Type : lithium, ref. Renata CR 2025
Note: Battery end of life is indicated to you by continuous
flashing of the digital display.
Used batteries, watch components and electronic
watches should not be disposed in litters, but correctly
recycled according to local regulations. We recommend
you to return such parts to your nearest dealer.
Timer mode Mode date
Care and maintenance