Thunder Tiger Titan X50 EF - Manual (Page 27)

-26-
Blade Tracking Adjustment / 主旋翼軌跡調整
CAUTION / 警告
For safety, ensure to keep a safe distance from the helicopter at least 10 meter (30 feet) while making tracking
adjustment.
安全起見，進行主旋翼軌跡調整時，請至少與直昇機保持10米（30呎）的安全距離。
1. Use a color tape at the tip of main
blades for tracking identification easily.
2. Increase the main blade speed to just
before the helicopter lifts-off.
3. Observe which blade appears to be
lower than the other, and increase the
pitch of the lower blade one turn of the
Linkage Rod A (refer Page 7) at a time
until each blade runs in track. If both
main blades rotate in the same path, it
doesn
,
t need to be adjusted.
1. 在主旋翼前端貼上色標可方便辨識軌跡。
2. 提高主旋翼轉速使機體稍懸浮於地面。
3. 觀察兩支旋翼軌跡是否有落差（雙槳），調
整軌跡較低旋翼上的連桿A (參閱第7頁) 長
度，一次調整一圈，直至兩支旋翼軌跡一致
。若軌跡一致則無需調整。
CAUTION / 警告
Out of track causes vibration, instability and a loss of power due to additional drag. Please adjust the tracking
repeatedly until the blades are in track properly.
旋翼軌跡落差（雙槳）會造成直昇機震動、不平衡及損失動力。請務必進行調整以使旋翼軌跡精準正確。
color tape / 色標貼
Out of Track / 雙槳
Adjustment is
necessary.
需要調整
color tape / 色標貼
Linkage Rod A
(refer Page 7)
連桿A (參閱第7頁)
In Track / 軌跡正確
Adjustment is
unnecessary.
不需要調整
A