Thunder Tiger RapRaptor E820 - Manual (Page 25)

Ensure there is none of the control bind at full travel before going through following setting procedures. Next, refer the
illustrations below to check the direction of servo & swashplate with a given transmitter input. Adjust the servo reversing
function in your transmitter if incorrect.
繼續設定前，請確認伺服機及連桿作動順暢且可達最大作動量。接著，請參考以下圖示，確認伺服機動作及十字盤混控設定可正確對
應撥桿動作。若作動方向不正確，請調整您發射機上的伺服機逆轉功能。
-24-
Swashplate & Servo Direction Setting / 十字盤及伺服機方向設定
Mold 1 Mold 2
Servo Horn movement
伺服機擺臂動作
Check Point
機構動作確認
Aileron
副翼
Front View / 前視圖
Right Side/右側 Left Side/左側
Elevator
升降舵
Left Side/左側
Pitch
螺距
Right Side/右側 Left Side/左側 Left Side/左側
Front View / 前視圖
Rudder
尾舵
Right Side/右側
Left View / 左視圖
Index of Linkage Length / 連桿長度索引
48.4mm / 1.91”
48.4mm / 1.91”
67.51mm / 2.66”
Fixed Length / 固定長度
74.53mm / 2.93”
Fixed Length / 固定長度