Denon DCD-F102 - Manual (Page 20)

Others
16
ENGLISH
ENGLISH
¢ Audio performance
No. channels: 2 channels
Frequency response: 2 Hz ~ 20 kHz
Dynamic range: 100 dB
S/N: 105 dB
Harmonic distortion: 0.005 % (1 kHz)
Separation: 95 dB
Wow & flutter: Below measurable limits (± 0.001 % W. peak)
Analog audio output: Output level : 2.0 Vrms (LINE OUT)
¢ Usable discs: Compact Disc
Diameter: 120 mm/80mm
¢ Signal format
Sampling frequency: 44.1 kHz
Quantization bit: 16-bit linear/channel
Transfer bit rate: 4.3218 Mb/seconds
¢ Digital output signal format
Format: Digital audio interface
Optical output: –15 ~ –21 dBm
Emission wavelength: 660 nm
¢ Pickup
Type: Objective lens drive type pickup
Objective lens drive type: Secondary parallel drive
Light source: Semiconductor laser
Wavelength: 780 nm
¢ General
Power supply: AC 230 V, 50 Hz
Power consumption: 15 W
Standby : 0.1 W or less
Maximum external dimensions: 250 (W) x 78 (H) x 250 (D) mm (Not including protruding parts)
250 (W) x 82 (H) x 260 (D) mm (Including protruding parts)
Mass: 2.9 kg
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
Page Measures Cause Symptom
Display does not light and
no sound is produced
when power is turned on. • Power supply cord is not plugged
into power outlet.
• Plug the power supply cord into the
power outlet.
6
“00 m 00 s” is shown on
the display even though a
CD is loaded. • The disc is not properly loaded. • Reload the disc. 2
Disc is not played when
1 / 3 button is pressed.
• The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
6
–
No sound is produced or
sound is distorted. • Incomplete connections with the
various devices.
• The receiver’s function setting or
adjustments are not right.
• Check the connections.
• Check the receiver’s function and
controls and adjust as necessary.
Specific section of the
disc cannot be played
properly. • The disc is dirty or scratched. • Wipe the dirt off the disc or replace
the disc.
3
Programmed playback is
not possible. • The tracks have not been
programmed properly.
• You are playing a disc containing files
in MP3 or WMA format.
• Program properly.
• Programmed playback is not
possible with containing files in MP3
or WMA format.
8
–
A CD-R or CD-RW disc
cannot be played. • The disc has not been finalized.
• The recording conditions are bad or
the quality of the disc itself it poor.
• Finalize the disc then play it.
• Use a properly recorded disc. 2
–
“Not Support” is
displayed when playing
riles recorded in MP3 or
WMA format. • You have selected a copyright-
protected WMA file or a file that
cannot be played normally.
• Use the 8 / 6 or 7 / 9
button on the main unit (the 8 or
9 button on the remote control
unit) to select a different file.
11, 12
3
Troubleshooting
Others