beautypg.com

Fak-5 and fak-5l: tee splice, Installation procedures – Thermon FAK-5 User Manual

Page 3

background image

4.

Wrap tube and heat trace with 1 pass of refl ective
tape (25% overlap), then wrap with 3 passes of
glass fi ber tape (50% overlap), or until fi ber tape
is equal to original bundle insulation thickness.

2a.

Zone Type Heat Tracing Only:

If bus connection indentation is less than 38mm
(1.5”) from end of the heat tracing, proceed stripping
the bundle insulation to the next indentation.

5.

Complete with additional passes of heat refl ective
tape.

1.

Remove outer jacket and insulation from tubing
bundle approximately 127mm (5”) from end of the
tubing bundle. Where required ensure suffi cient heat
trace is available for electrical splice. See instructions
included with heat trace kit.

127mm

(5”) TYP.

Heating Cable Splice

(if required)

3.

If bundle includes electric heat trace, make-up splice
per instruction included with heater cable kit. This
should be accomplished after fi ttings are leak tested.

6.

Cut splice cover ends to match outside diameter of
tubing bundle. These can be discarded.

7.

Form a gasket by applying RTV sealant to bottom
half of splice cover and along radius of upper half.

8.

Fit tubing bundle to bottom half of cover and install
top half. Screw down fi rmly. Inspect ends of tubing
splice cover for snug fi t. Apply additional RTV sealant
where needed.

RTV

Sealant

Splice Cover

Top

Tubing Fitting

Splice

Cover End

Splice Cover

Bottom

Splice Cover

Top

Splice Cover

Bottom

Splice Cover

Bottom

Tubing Bundle

(SE/ME Shown)

Tubing Bundle

2

Do not cut or damage the heat trace.

(Found on TubeTrace SE/ME bundles)

CAUTION

Bus Connection

Indentations

(Zone Heater Only)

2.

Cut 38mm (1.5”) off the end of the tubing and
make tube fitting connections with appropriate
fi ttings, provided by others. If no electrical heat trace
is present, go to Step 4.

FAK-5 and FAK-5L: Tee Splice

INSTALLATION PROCEDURES

This manual is related to the following products: