Thermon MIQ Mineral Insulated Heating Cable v.1 - Manual (Page 7)

INSTALLATION PROCEDURES
Illustration H: Pipe Hanger . . .
Heating Cable
Tie Wire or
Banding (TYP.)
Illustration I: Socket Weld Valve . . .
Pipe Hanger
MIQ Heater Cable
Stainless Steel Tie Wire
or Banding
Notes. . .
1. For small valves (less than 50 mm) it may be impractical to install the correct cable
allowance on the valve body itself. It can be installed in a uniform manner across the
valve and either side of the pipe as shown above .
2. At tee branch pipe line (less than 50 mm) if the branch pipe is double traced and
the main pipe is single traced, then there is no additional requirement for cable
allowance for valve.
Stainless Steel Tie Wire
or Banding
MIQ Heater Cable
Installation on Tanks and Vessels . . .
Always install MIQ cable longitudinally on surface of tanks
or vessels. Never spiral wrap MIQ around circumference of
tanks or vessels.
6