Tech Source Condor 2000 Series User Manual

Page 5

Condor 2000 Series User’s Guide

Part #65-0286-04 Rev A

Hardware Installation

2.1

2.1 Installation Instructions

Installation Instructions

The Condor 2000 Series graphics card installation is simple and consists of a few easy steps.

Step 1:

Shut down the system and turn the power OFF. Remove the single board computer. Be
mindful of ESD, and be sure to use proper ESD precautions.

Step 2:

Install the Condor 2000 Series graphics card using the provided mounting hardware.
Attach the Condor graphics card to the PMC/XMC connector and screw down the
standoffs. For a conduction cooled board, the SBC company should have provided
mounting screws.

Step 3:

Re-install the single board computer, attach any previously removed cables, and connect
the video cable to your monitor.

The Condor 2000 Series graphics card is now installed and the system is ready for display driver
installation.

Refer to Section 3

Section 3

Section 3 for installing and configuring the display driver on Linux.

Refer to Section 4

Section 4

Section 4 for installing and configuring the display driver on Windows.

NOTE:

NOTE: Once cables are connected, you may want to label them and the

connectors to avoid any confusion should they need to be disconnected.

NOTE:

NOTE: Rear I/O will require a special/custom cable, RTM or PIM to get a
video output. For rear I/O pin-out info, please refer to the Condor 2000

Condor 2000

Series Technical manual