Tecfluid DP Series - Manual (Page 9)

9
Mounting length:
DP65: 65 mm DN40 … DN300
DP500: 500 mm DN250 … DN300
600 mm DN350 … DN400
700 mm DN500
Optional limit switches in the indicator housing:
DP-AMM
1 or 2 micro-switches with potential free contacts
Maximum current: 3A
Máximum voltage: 250 VAC
DP-AMD
1 or 2 slot inductive sensors, acording to EN60947–5-6 (NAMUR)
Power supply: 8.2 VDC
Optional transmitters:
TH5
Position transducer, with analog output. 2-wire connection.
Power supply: 12 ... 36 VDC
Output signal: 4-20 mA
TH5T
Position transducer, with totalizer and analog output. 2-wire connection.
Power supply: 12 ... 36 VDC
Output signal: 4-20 mA
TH5H
Position transducer, with analog output. 2-wire connection.
Power supply: 18 ... 36 VDC
Output signal: 4-20 mA
HART protocol
TH5TH
Position transducer, with totalizer and analog output. 2-wire connection
Power supply: 18 ... 36 VDC
Output signal: 4-20 mA
HART protocol
Conforms with the Pressure Equipment Directive 97/23/EC
This equipment is considered as being a pressure accessory and NOT a safety accessory
as defined in the 97/23/CE directive, Article 1, paragraph 2.1.3.
Conforms with Directive 2006/95/EC (Low Voltage)
Conforms with Directive 2004/108/EC (Electromagnetic compatibility)
Conforms with Directive 2002/96/EC (Waste electrical and electronic equipment)
All the limit switches and transmitters can be optionally supplied for use in potentially
explosive atmospheres.
ATEX certification
II 1 GD Ex ia IIC T4 or T6