Teac DV-RA1000HD - Manual (Page 30)

0
TASCAM DV-RA1000HD
Playback
The following apply when the DV-RA1000HD is used
to play back CD, CD-R or CD-RW discs. Many of these features also apply to playback of DVD and HD record-
ed on the DV-RA1000HD.
Basically, the DV-RA1000HD works in the normal way
as a CD player and in a very similar way to many CD
recorder.
However, there are a number of features that may not be
immediately obvious.
Functions marked with a DVD or HD indicator in this
chapter are available for DVD or HD playback respec-
tively. Functions marked with a DVD±RW or HD are
available for DVD±RW or HD recording respectively.
DVD refers to both DVD±RW and DVD±R, and HD
refers to the HD of DV-RA1000HD.
Certain functions are not available in DSD mode, and
this is noted in the corresponding sections.
The transport keys enable you to play a disc as if you
were using a standard CD player.
To start playback, press the PLAY key while
the transport section is stopped or playback
is paused.
To stop playback, press the
STOP key.
To pause playback, press the READY key.
To resume playback after the playback is
paused, press the PLAY key.
To mute the playback signal (i.e., silent play-
back), press the MUTE key. Press the MUTE
key briefly to mute the signal. Press the
•
•
•
•
MUTE key again to unmute the signal. Press
and hold the MUTE key to mute the signal
until you release the key. Release the MUTE
key to unmute the signal. While the signal is
muted, the MUTE key indicator lights up.
To skip the tracks backward or forward,
press the / keys.
To perform cue search during playback,
press and hold the / keys on the front
panel or the / keys on the remote con-
trol unit. You will hear an intermittent fast
playback sound at a very low volume.
•
•
Basic playback operation DVD HD
Use the DISPLAY key on either the main unit or the
RC-RA1000 remote control unit to cycle through track
elapsed time, track remaining time, total elapsed time,
and total remaining time (on playback).
While recording, track elapsed time and recording
remaining time are the only options available.
In stopped mode, the choices are track elapsed time,
track remaining time, total time, total remaining time
(and recording remaining time on recordable discs).
Display DVD HD
To program the order of track playback, use the pro-
gram list accessible from the Virtual Front Panel. (See
“The virtual front panel (VFP)” on page 23.) The
PGM
key on the remote control unit can also be used to
access this screen and turn programmed playback on
and off.
The order of programmed playback is not stored when
power is turned off.
When programmed playback is turned on, the screen
shows a list of tracks which can be edited as follows:
Figure 5.1: Programmed playback
Use the JOG/DATA dial to scroll through the
list of tracks at the left of the screen.
Add tracks to the end of the program list
using the F1 ( ADD ) key.
•
•
Programmed playback DVD HD
5 − CD playback & recording