Teac DVW-D13A - Manual (Page 29)

12.4 Format HDD
TEAC Tower DVD Duplicator User’s Manual 21
12.4 Format HDD
(For factory use only; please do NOT use this function.)
The Format HDD option is valid only on Tower DVD Duplicators that feature a
factory-installed hard disk drive. The factory-installed hard disk drive has already
been partitioned and formatted and is ready for use.
12.5 Verify HDD
(For factory use only; please do NOT use this function.)
The Verify HDD option is valid only on Tower DVD Duplicators that feature a
factory-installed hard disk drive. The factory-installed hard disk drive has already
been partitioned and formatted and is ready for use.
12.6 Burn-in
The Burn-in function runs an emulate writer function continuously. The disc in the
target drive is ejected and re-inserted automatically between each test cycle. This
function can be prepared to run continuously or specified to run from 1 to 1000
times.
12.7 Update Firmware
The Update Firmware function updates the firmware of the interface board via a
CD or DVD disc. The disc must contain the required data file and be inserted in
the source drive. The DVD Duplicator will locate the data and update its firmware
automatically. During the update, do not turn off the power to the unit. The update
process is complete after the system resets automatically and displays the main
menu.
12.8 Compare Firmware
The Compare Firmware function compares the current firmware version in the
interface board to the update version in the CD or DVD disc.
12.9 H/W Diagnostic
The H/W Diagnostic function detects the devices connected to the interface board,
confirms functionality, and displays information about the hardware on the LCD.
Warning! Do not run this function. It will erase all data already loaded into disk
partitions. This function is reserved for factory use only.
Warning! Do not run this function. It will erase all data already loaded into disk
partitions. This function is reserved for factory use only.
TEACdvwd17h.book Page 21 Sunday, May 1, 2005 6:28 PM