Teac AD-RW900-B - Manual (Page 34)

34
Manual track division
It is possible to divide a track into multiple tracks by pressing the
RECORD button (K RECORD) while recording.
< Manual track division is possible regardless of the AUTO setting.
< A track cannot be less than 10 seconds in length. The RECORD
button (K RECORD) will not work if it is pressed within 10 seconds
from the beginning of a track.
LINE IN PHONO
Recording on a CD (3) Synchronous recording to CD
LINE IN PHONO
The convenient synchronous recording function automatically starts
recording when receiving analog or digital signals from an externally
connected device such as a CD player and MD deck, and stops record-
ing when signal reception is complete.
For CD, MD, or DAT
Synchronous recording starts when a digital signal is detected,
which is the beginning of a track. Synchronous recording stops if
there is a period where the sound is quieter than the specified auto
track level lasting five seconds.
For digital sources other than the above or analog sources
Synchronous recording starts when a sound louder than the speci-
fied auto track level is detected. Synchronous recording stops if
there is a period where the sound is quieter than the specified auto
track level lasting 8 seconds.
1
Complete steps 1 to 5 in “About Recording” to make
the settings, and press the CD stop button (H).
< Since the recording level cannot be adjusted when the
recording source is the digital input ( ), skip steps 4 and
5
.
2
Press the SYNC button and select “SYNC 1” or “SYNC
ALL”.
Each time you press the sync recording button (SYNC), the sync
recording will change.
ALL YONE YOFF
Select one of three modes.
ALL
Sync recording of all
tracks.
ONE
Sync recording of one
track and then recording
stops.
OFF
No sync recording.