Teac DR H338i - Manual (Page 20)

20
< You can also select FM or AM by pressing the TUNER button on
the remote control unit once or twice.
< You can also select iPod or USB by pressing the iPod/USB button
on the remote control unit once or twice.
< To listen to an external source connected to the AUX IN jack,
select AUX1 or AUX2.
< You can also select AUX1 or AUX2 by pressing the AUX button
on the remote control unit once or twice.
3
Play the source, and adjust the volume using the VOLUME
knob.
The volume is adjustable from MIN to MAX. You can hold down
the VOLUME – or + buttons on the remote control unit to reduce
or bring up the volume continuously.
< Press the STANDBY/ON button to put the unit in the standby
mode when it is not being used.
< If you press the STANDBY/ON button to put the unit in the
standby mode when SOURCE is set for AUX1 or AUX2, first, the
speaker sound stops and then after about 2 seconds the output
to the sub woofer stops.
This chapter describes the basic operation which is available in every
mode.
When you use the unit for the first time, set the clock and the setting
of the unit. (see previous page for “Setting the Clock”, page 37 for
“Settings”).
1
Press the STANDBY/ON button to turn the unit on.
< The unit turns on with the source that was last selected.
< You can also use the SOURCE button (or the TUNER, DISC, iPod/
USB or AUX button on the remote control unit) to turn the unit
on.
2
Press the SOURCE button to select a source.
Each time the SOURCE button is pressed, the source changes as
follows:
FM Radio
AM Radio
AUX1 Source
AUX2 Source
iPod
DISC Source
USB Source
The selected source is shown on the front panel’s display.
Basic Operation (1)