Q-See QSDL503AD - Manual (Page 8)

QSDL503AD USER MANUAL
6 | P a g e
(Picture 8)
Section 6: SETTING UP THE MAGNETIC CODE CONTROLLER
Pressing the ARM button once on the Magnetic Code Controller will activate it after 30 seconds. After 30
seconds, the Controller is actively on and protecting the doorway that you chose to mount it on. You must
deactivate the Magnetic Code Controller in order to gain access to the doorway by entering in a 4-digit
Access Code.
The default Access Code on your Magnetic Code Controller is 0123. To change this number, hold down
the ARM button continuously for 3 seconds until you hear a beep. Press the 4 digit code of your choice
followed by the ARM button. You have now reset your Magnetic Code Controller Access Code. You
must use this Access Code to deactivate your Magnetic Code Controller and to turn off the alarm in the
event that the door the Controller is protecting has been opened improperly.
Arm Button – Press to set
Your Magnetic Code
Controller in Arm Mode
Alarm Button – Press to
Instantly Activate the
Alarm in the event of an
emergency