TE Technology TCA - Manual (Page 12)

TE
TECHNOLOGY, INC.
12/22
http://www.tetech.com email: [email protected]
TE TECHNOLOGY, INC.
157 157 127 172.2 CP-121
82 132 139.7 88.9 CP-061, AC-053
157 221 241.3 161 CP-200, CP-200HT,
CP-200TT, CP-200HTTT
145 230 246.4 161 AC-140, AC-194
85 167* 127 104.6 LC-035
85 192* 152.4 104.6 LC-061
145 221 241.3 161 AC-162,CP-218
157 281* 241.3 161 LC-200
97 157 190.5 114.3
AC-073,
CP-110, CP-127
85 132 152.4 104.6 AC-046, CP-065
85 107 127 104.6 AC-027, CP-036
W (mm) L (mm) B
(mm)
A
(mm)
TCA
157 157 127 172.2 CP-121
82 132 139.7 88.9 CP-061, AC-053
157 221 241.3 161 CP-200, CP-200HT,
CP-200TT, CP-200HTTT
145 230 246.4 161 AC-140, AC-194
85 167* 127 104.6 LC-035
85 192* 152.4 104.6 LC-061
145 221 241.3 161 AC-162,CP-218
157 281* 241.3 161 LC-200
97 157 190.5 114.3
AC-073,
CP-110, CP-127
85 132 152.4 104.6 AC-046, CP-065
85 107 127 104.6 AC-027, CP-036
W (mm) L (mm) B
(mm)
A
(mm)
TCA
TCA Mounting Hole Dimensions
SCREW AND WASHER ONLY FOR: AC-027, AC-046, AC-053, CP-036,
CP-061, CP-065, CP-121, LC-035, LC-061
BOLT, NUT, AND WASHER FOR: AC-073, AC-162, AC-140, AC-194, CP-110,
CP-127, CP-200, CP-218, LC-200
NOTE: Only AC-xxx
units have gasket for
sealing the opening.
Use sealing washers
and appropriate
sealant on gasket
surface and
mounting hardware
to achieve rated
sealing.
* This length dimension is required to prevent interference with tubing. The heat
sink face will not completely seal against the outside surface of the opening.