SVS TMD - Manual (Page 4)

•
The TMD Lift is provided with a standard AC power cord. The TMD is designed to use a standard wall
socket. A qualified electrician must do any other electrical wiring. Always follow local building
and electrical codes.
3. PRE-INSTALLATION CONSIDERATIONS
•
Please inspect the unit for any shipping damage. If the lift has been damaged during transport, do not
proceed with the installation. Please contact the carrier's claim agent.
•
Ensure that you have the require space to install the TMD Lift with your screen or projector attached.
•
Ensure that your cabinet will support the weight of the TMD lift and screen or projector.
•
Consider how you will install the necessary cabling for the lift and screen or projector (low voltage
control, audio, video, and/or AC Power cables).
•
Do not install the screen or projector on the lift until the lift, hardware, and any other accessories have
been properly installed and are operational. Failure to maintain proper clearance could result in damage
to the screen, projector, furniture, and/or lift.
•
The upper limit of the TMD Lift has been adjusted at the factory. Adjustment of the upper limit by
other than SVS personal will void the lift warranty.
•
The weight of the screen or projector should be balanced right to left on the TMD telescoping column.
The projector balance point should be placed over the column of the TMD lift.
•
Consider how you will access the lift and electrical connections after the lift is installed.
4. DIMENSIONAL INFORMATION
•
The TMD Lift is 7 5/8-inches (19.36 cm) wide by 12-inches (30.48 cm) deep by 21 15/16-inches (55.72
cm) high in the lowered/closed position. The raised/open height is 50-inches (127 cm).
•
Inside cabinet height will need to be at least 22-inches. And 25 1/8-inches with Closure Adapter Kit.
•
Inside cabinet width will be determined by the width of the plasma/LCD screen. Remember to allow
adequate clearance on each side of the screen. If you are installing a projector on the TMD lift, the
inside width will be determined by the width of the projector platform. The projector platform will
be custom made to fit your projector. If you are using the Closure Adapter Kit your Minimum width
will need to be 24-inches.
•
Inside cabinet depth must be at least 12-inches to accommodate the TMD lift for most Plasma and
LCD screens. The cabinet depth for projectors will be the projector platform depth. Depth will need
to be at least 14-inches with the Closure Adapter Kit.
•
All inside dimensions will need to accommodate the top closure plate that you are using.
See TMD Dimension, TMD Projector, and TMD Closure Drawings in Section 9.