SVS PLASMA TWO - Manual (Page 7)

If ceiling clearance allows, an "X-Y" or a cross-supporting structure is strongly suggested (as shown in
Figure 5a and 5b). This will allow front-to-back or side-to-side adjustments if the lift is found to still be
slightly offset with the screen once it has been installed.
SVS PLASMA TWO LIFT MOUNTING ON EXISTING BEAMS
Figure 5a.
SVS PLASMA TWO LIFT MOUNTING ON A FLAT CEILING
Figure 5b.
SVS PLASMA TWO LIFT INSTALLATION Page 7 of 13
ALWAYS FOLLOW THE LOCAL BUILDING
CODES. SVS RECOMMENDS ALL MOUNTING
HARDWARE BE RATED TO HANDLE 4 TIMES
THE WEIGHT OF THE PROJECTOR
AND LIFT OR WHICH EVER NUMBER
IS HIGHER.
X - UNISTRUT
USE 10'LENGTH WHEN
POSSIBLE ON EACH X AXIS
UNSTRUT CHANNEL NUT
P3010 WITH WASHER
AND RETAINING NUT.
8 PLCS.
.375" FOR MINI 4
AND LCD LIFTS
.50" ALL OTHER LIFTS
P1000T 2 PLCS.
2 PLCS.
Y - UNISTRUT P1000 T
1/2" THREADED
RODS 4 PLCS.
M
= MOUNTING HOLES
M
THREADED ROD, 4 PLCS
USE NO LESS THAN EIGHT 1/2"
MACHINE THREAD SHIELDS AND
BOLTS TO SECURE TO CEILING.
MOUNTING MATERIALS NOT SUPPLIED BY SVS, INC.
M
M
M
EXISTING
X - UNISTRUT P1000 T
BEAM CLAMP
UNISTRUT P2824
UNSTRUT CHANNEL NUT
P3010 WITH WASHER
AND RETAINING NUT.
8 PLCS.
.375" FOR MINI 4 AND
LCD LIFTS
.5" FOR ALL OTHER
LIFTS
4 PLCS.
BEAMS
2 PLCS.
2 PLCS.
Y - UNISTRUT P1000 T
1/2" THREADED
RODS 4 PLCS.
M
M
M
2 PLCS.
= MOUNTING HOLES M
M
THREADED ROD, 4 PLCS.
ALWAYS FOLLOW THE LOCAL BUILDING
CODES. SVS RECOMMENDS THAT ALL MOUNTING
HARDWARE IS RATED TO HANDLE 4 TIMES
THE WEIGHT OF THE PROJECTOR
AND LIFT OR WHICH EVER NUMBER
IS HIGHER.
DO NOT EXCEED RATING OF
UNISTRUT BY SPANNING TOO GREAT
OF A DISTANCE.
* MOUNTING MATERIALS NOT SUPPLIED BY SVS, INC.