Super Systems AC20 Quick Start - Manual (Page 3)

Super Systems Inc. 3 1 (800)-666-4330
Cincinnati, OH 45241 Fax: (513) 772-0060
//Ssio1/main/.ssimanuals/ac20qs www.supersystems.com
Display Indicators
Press the FUNC button to change the bottom display to the following.
mV Lit when the sensor out (in mV) is shown on the lower display.
TP Lit when the sensor temperature is shown on the lower
display.
CP/DP DP Lit when instrument is in % control mode
CP lit when instrument is in dew point control mode
COF Lit when the carbon monoxide factor is shown on the lower
display.
(Only used when controlling Carbon Potential)
H2F Lit when Hydrogen factor value is shown on the lower display.
(Only used when controlling DewPoint
K Lit when the probe resistance value is shown on the lower
display
SEC Lit when the sensor response time is shown on the lower
display
LT Lit when the probe temperature of the last probe test is shown
on the lower display
Other LEDs Displayed:
1 – Lit when:
- Out 1 is used as control output and it is ON condition
- Alarm 1 is in alarm state and acknowledged.
Flashes when alarm 1 is in alarm state and it is not acknowledged.
2 – Lit when:
- Out 2 is used as control output and it is ON condition
- Alarm 2 is in alarm state and acknowledged.
Flashes when alarm 2 is in alarm state and it is not acknowledged.
3 – Lit when:
- Out 3 is used as control output and it is ON condition
- Alarm 3 is in alarm state and acknowledged.
Flashes when alarm 3 is in alarm state and it is not acknowledged.
SSi
AC20 Quick Start Instructions