Danby DWC1534BLS - Manual (Page 11)

10
Before You Call For Service
If none of the above rectify the situation please contact our customer care department
at 1-800-26- (1-800-263-2629)
Trouble Shooting
R
Problem Possible Cause What to do
No Power A fuse in your home may Replace fuse or reset circuit breaker.
be blown or the circuit
breaker tripped.
Power surge. Unplug the wine cooler, wait a few
seconds and then plug it back in.
Plug not fully inserted into Make sure the 3-prong plug on the
wall outlet wine cooler is fully inserted into outlet.
Cabinet Temperature Temperature setting Verify the temperature control setting.
too High Adjust if neccessary.
Door not shut properly Ensure that the door is fully closed
or opened excessively and that the gasket is sealing
against the cabinet. Open the door
only as needed and for short periods
of time.
Recently added a large Limit the quantity of warm bottles
quantity of warm bottles being introduced to the cabinet at the
to the cabinet same time. Attempt to phase in the
load introduction if possible.
“Clicking” Noise Normal sound No user intervention is required as
this sound is normal during the opera-
tion of the appliance. This audible
‘clicking’ noise may be heard as the
wine cooler ends or begins a cooling
cycle.
Condensation on the High humidity conditions The condensation will subside once
cabinet and/or door in the home humidity conditions return to normal.
Door not shut properly Ensure that the door is fully closed
or opened excessively and that the gasket is sealing
against the cabinet. Open the door
only as needed and for short periods
of time.