Sun Pumps SCB-10-150-120 BL - Manual (Page 4)

2.1 Controller Features
1. Current boosting for matching the load requirements of the pump.
2. Voltage regulation of the solar electric array at its maximum power point. (MPPT)
3. Over-current protection via integrated electronic circuit breaker.
4. Reverse polarity protection (10 amperes maximum) on the input terminals.
5. Voltage and current limiting to pump motor.
6. Transient protection and surge suppression.
7. Adjustable output motor power control for precision output flow.
8. Digital display indicating status, power, voltage, current and more.
9. System ON/OFF switch.
10. LED indicators; 1. Power In, 2. Motor Run, 3. MPPT, 4. RS Stop, 5. Low Power, 6. Over-
Current, 7. Fault Condition.
11. Weather resistant powder coated, die cast aluminum enclosure with a hinged door.
12. Rising clamp screw terminal blocks – no fork terminals required.
13. Pre-adjusted pump configuration and power source selection.
14. Remote switch interface – float switch or remote shutdown –Normally Open or Normally
Closed, user selectable.
15. Sensorless “Low Water” circuit
16. Low Power Shut Down circuit
2.2 Application
The only application the PCC series controllers are designed for is the interface between a solar module
array and SunPumps Sensorless Brushless DC motors.
No other applications or DC power sources are recommended or warranted unless written
approval is provided by the SunPumps factory.
3.0 Installation and Operation
The following sections are outlined in a step-by-step format to guide you through the installation and
configuration of an SCB series pump and PCC series controller. The procedure for installing the SCB
submersible pump is the same as a standard AC submersible pump. Any licensed pump contractor will be
familiar with the proper installation procedures. The installation and operation should be in accordance
with local regulations, accepted codes of good practice and common sense. This pump should be installed
by a licensed professional pump installer.
Before installing any pump system read all product manuals then review all system components to
become familiar with the physical and electrical layout. Check all equipment for any product damage.
Refer to applicable figure(s) as a guide during the installation. Controller door must be closed during
normal operation.
Warning
Reverse polarity on a panel system capable of producing over 10 amps will result in
non-warranted product damage. Please check polarity before connecting power to the
controller.
This controller is for SunPumps Sensorless Brushless DC Motors only. Do not use this
controller on AC, Brush-Type or Sensor Type Brushless DC motors. Damage to the
controller and/or motor will result.
3.1 Location