Studio Technologies 55 1996 - Manual (Page 35)

Model 55/56 User Guide Issue 3, December 1996
Studio Technologies, Inc. Page 35
Model 38 Talent Amplifier
Mounting
Desktop. Provision for stand mounting provided.
Power Requirements
+20-32Vdc (modulated with left channel audio),
provided by Model 55 Central Controller
Power Present LED
Red LED indicates presence of operating power
Connectors
Cue Mix Input (from Model 55): 3-pin XLR-type,
female (Neutrik)
Cue Mix Input Loop Thru: 3-pin XLR-type male,
connected in parallel with input connector (Neutrik)
Talent Input (Left In/Mono and Right In): 3-pin
XLR-type, female (Neutrik)
Talent Input Loop Thru: 3-pin XLR-type male,
connected in parallel with input connectors
(Neutrik)
Headphone Outputs: 2, ¼-inch, 3-conductor
(stereo) phone jacks, gold-plated contacts
(Neutrik)
Cue Mix Input
Intended for connection only with Model 55 Central
Controller
Talent Input
Qty: 1, stereo or mono, switch selectable
Type: electronically balanced, capacitor coupled,
input impedance 20k ohms
Input level: switch selectable for microphone or
line-level signals. Expected signal level: Mic
position –40 to –60dBu, Line position –10 to
+10dBu.
Headphone Output
Qty: 1, feeds two headphone jacks
Load: intended for connection to one or two pairs
of headphones with total impedance of 75 ohms or
greater
Output Level: user adjustable
Maximum Output Voltage: 16V peak-to-peak into
150 ohms @ 1% THD+Noise, 400Hz
Distortion (THD+N): 0.1%
Frequency Response: 20Hz-20kHz +0.5dB
Dimensions (Overall)
8.0 inches wide (20.3cm)
2.0 inches high (5.1cm)
5.4 inches deep (13.7cm)
Weight
1.5 pounds (0.7kg)
Model 70 Interface
Power Requirements
+20-32Vdc (modulated with left channel audio),
provided by Model 55 Central Controller
Power Present LED
Red LED indicates presence of operating power
Connectors
Input (from Model 55): 3-pin XLR-type, female
(Neutrik)
Loop Thru: 3-pin XLR-type, male, connected in
parallel with input connector (Neutrik)
Left and Right Line Outputs: 3-pin XLR-type, male
Line Output
Qty: 1, stereo
Type: electronically balanced, intended to
drive loads of 600 ohms or greater, balanced
or unbalanced
Nominal Output Level: +4dBu
Maximum Output Level: +20dBu into 10k ohms,
+19dBu into 600 ohms
Frequency Response: 20Hz-20kHz +0/–0.5dB
Distortion (THD+N): 0.02%
Dimensions (Overall)
4.2 inches wide (10.7cm)
2.0 inches high (5.1cm)
5.3 inches deep (13.5cm)
Weight
0.8 pounds (0.4kg)
Specifications and information contained in this
User Guide subject to change without notice.