Studio Technologies 55 1996 - Manual (Page 20)

Issue 3, December 1996 Model 55/56 User Guide
Page 20 Studio Technologies, Inc.
While holding Level Up, the slate LED is
used to display whether talk to phones will
interrupt the phones source, or add to the
phones source. When the LED is off, the
selected phones source will be interrupted
and the communications audio source will
be connected; when the LED is on the
communications audio source will be add-
ed (mixed) to the phones audio source.
While holding Level Up, press the button
below the LED to toggle the setting.
Allow Two Simultaneous Control Room
Sources
A feature has been added that allows any
two of the four input channels to be simul-
taneously selected for monitoring over the
control room output. This was added for
applications where multiple “rough” or
“scratch” audio signals need to be moni-
tored at the same time. This feature can
be enabled or disabled using the configu-
ration procedure on the Model 56 Control
Console.
Reset Factory Defaults
Provision has been made to allow you to
return all configurable parameters to the
factory default values. With the Model 56
in the configure mode, press and hold both
the Dub and Phones buttons. After two
seconds the factory defaults will be stored
in memory, the configure mode will auto-
matically end, and the Model 56 will return
to normal operation.