Directed Electronics 64602610 400.2 User Manual

Page 8

1. SSppeeaakkeerr OOuutt TTeerrm

miinnaallss - Connect

the speakers to these terminals.
(Refer to the

Speaker Connection

section of this guide.)

2. RReem

moottee TTuurrnn OOnn - This terminal

turns on the amplifier when (+) 12
volt is applied to it. Connect it to
the remote turn on lead of the head
unit or signal source. If a (+) 12
volt remote turn lead is not avail-
able, a Remote Power Adapter

(P/N #55000) can be used to
supply a remote turn on signal. DO
NOT connect this terminal to
constant (+) 12 volt.

3. PPoow

weerr FFuusseess - These fuses protect

the amplifier against internal elec-
trical damage and are meant to
protect the amplifier only. All other
power connections should be fused
at the source.

REAR PANEL CONNECTIONS

1. RRCCAA OOuuttppuutt JJaacckkss - These pass

through RCA jacks can be used to
send a signal to a second amplifier.

2. RRCCAA IInnppuutt JJaacckkss - Accepts line level

outputs from head units or signal
processors at voltages between
150mV and 8 volts.

3. SSttaattuuss LLEEDD - Will light green to indi-

cate the amplifier is on and oper-
ating normally and will be off if the
amplifier shuts down due to short
circuit, DC offset, or overheating
detected by on-board protection
circuitry.

FRONT PANEL CONNECTIONS/STATUS LED

FIGURE 1—AMPLIFIER CONNECTIONS 400.2 FRONT