Directed Electronics 64602610 400.2 - Manual (Page 10)

10
© 2002 Directed Electronics, Inc
TOP PANEL CONTROLS
FIGURE 3—AMPLIFIER CONTROLS TOP
4
1. IInnppuutt GGaaiinn AAddjjuussttm meenntt - Controls
amplifier sensitivity and is used to
match the input level of the ampli-
fier to the output level of the signal
source.
2. CCrroossssoovveerr SSeelleeccttiioonn SSw wiittcchh -
Controls the type of filter for the
onboard active crossover. FLAT does
not attenuate any frequencies and
is for full range speaker systems.
HPF attenuates low frequencies and
is used for mid range speakers and
tweeters. LPF attenuates high
frequencies and is used for
subwoofers speakers.
3. CCrroossssoovveerr FFrreeqquueennccyy AAddjjuussttm meenntt -
Adjusts the crossover point for the
on board active crossover.
4. VVaarriiaabbllee BBaassss EEQQ - Adds 0 to12db
of additional boost to the speaker
output when active.
1 3 2