Southern States CSH - Manual (Page 9)

Title: Southern States – CSH & CSH-B
Horizontal Interrupter Style Circuit Switchers
Product Specification Guide
purchase order, the instruction book(s) will be forwarded to the same individual
that the approval drawings were sent to.
8.04 Additional Documentation
One complete set of final drawings and one copy of each applicable instruction
book shall be shipped in a weatherproof envelope with each circuit switcher.
9.0 SHIPPING and DELIVERY
The circuit switcher shall be match-marked and disassembled as necessary to
accommodate shipping dimensional clearance restrictions or shipped assembled on its
common subframe. The circuit switcher phases shall be shipped fully assembled on
insulators, minimizing the amount of field installation time required. Each interrupter
shall be shipped with a positive pressure of 5 – 10 psi of SF
6
, eliminating the need to
pull a vacuum on the interrupters in the field. An SF
6
fill kit shall be provided to fill each
interrupter to rated pressure during installation.
10.0 WARRANTY
All circuit switchers and their accessories furnished under this specification shall be
covered by a five-year warranty from date of shipment against failure due to design
or to defects in workmanship or material.
11.0 SPECIFIC QUOTE REQUIREMENTS
Information furnished by purchaser at time of quote request will include:
1. Model type (blade or non-blade)
2. kV rating
3. Continuous current rating .
4. Maximum System Fault Available
5. Motor / Control voltage (48 VDC or 125 VDC)
6. Heater voltage (120 VAC or 240 VAC)
7. Mounting pedestal height
8. Phase spacing
9. If manufacturer is to supply anchor bolts
10. Additional requirements, if applicable (see section 3.02.05)
12.0 ACCEPTABLE CIRCUIT SWITCHER
Supply Southern States type CSH (non-blade model) or CSH-B (blade model) or
acceptable equal. Any equal proposed must meet or exceed this specification.
Page 9 of 9 Publication No.: PSG-803-032615