beautypg.com

03 resistance tests, 01 current path resistance test, 02 heater resistance test – Southern States CSH User Manual

Page 8: 04 dielectric tests, 01 control circuit dielectric test, 02 interrupter dielectric test, 0 spare parts, 0 documentation requirements, 01 approval drawings, 02 final drawings

background image

Title: Southern States – CSH & CSH-B

Horizontal Interrupter Style Circuit Switchers

Product Specification Guide

6.03 Resistance Tests

6.03.01 Current Path Resistance Test

A terminal-to-terminal micro-ohm resistance check shall be performed on
each interrupter using a 100 A DC source and the values shall be
recorded.

6.03.02 Heater Resistance Test

The resistance of each heater shall be confirmed to be within
specifications and the values shall be recorded.

6.04 Dielectric Tests

6.04.01 Control Circuit Dielectric Test

The completely assembled and wired operator control circuit shall pass a
dielectric test of 1500 V for 1 minute.

6.04.02 Interrupter Dielectric Test

Each interrupter shall pass a power frequency withstand test at 60 Hz for
one minute. The required test value shall be at least three times rated
line-to-ground voltage.

7.0 SPARE PARTS

No spare parts shall be required to be purchased at the time of circuit switcher
purchase. Stock shall be maintained at the manufacturer available for rush shipment in
the event of an emergency need.

8.0 DOCUMENTATION REQUIREMENTS

8.01 Approval Drawings

The manufacturer shall furnish approval drawings in AutoCAD .DWG format via
e-mail. The purchase order will designate the name and e-mail address of the
individual where the drawings should be forwarded. If there are no comments to
the approval drawings purchaser will respond via e-mail that drawings are
approved as submitted with no changes. If comments are required then one
copy of the drawings will be returned to the manufacturer within 10 days from the
date of transmittal marked “approved with comments as noted”.

8.02 Final Drawings

The manufacturer shall furnish final drawings in AutoCAD .DWG format via e-
mail. Unless otherwise specified in the purchase order, the final drawings will be
forwarded to the same individual that the approval drawings were sent to.

8.03 Instruction Books

The manufacturer shall furnish an electronic copy of each applicable instruction
book in Adobe Acrobat .PDF format via e-mail. Unless otherwise specified in the

Page 8 of 9

Publication No.: PSG-803-032615

This manual is related to the following products: