I series – Soundtube CM800d User Manual
Page 3

CM
i Series
If not painting
If painting
12.
Attach grille & bezel
seismic restraint to baffle
with provided screw.
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
1.
Unpack speaker & set
aside grille assembly.
2.
Keep Styrofoam
installation aid/paint mask
attached to speaker until
speaker installation is
complete.
3.
Use included tile bridge
to mark cutout in sheetrock.
4.
Use Rotozip or other tool
to cut hole. Hole diameter
325.1 mm (12.80 in)
11.
Select the tap position
by adjusting rotary switch
to desired high impedance
value or voice coil bypass
mode. Switch is preset to
maximum tap setting in
70.7 V mode.
13.
Attach grille – position the
grille over the baffle and allow
magnets to attract grille into
place. Be sure grille is properly
centered over baffle.
9.
If you are not painting the
ceiling, remove & discard the
paint mask.
10. If you are painting
the
ceiling after the speaker is
installed, leave the paint mask
in place until paint is dry.
Sheetrock Ceiling Install Instructions For:
CM800d, CM890d and CM1001d speakers
8.
Insert speaker into
mounting hole with install-
ation aid in place. Tighten
both bolts located on the
baffle face to actuate the
mounting wings. Firmly
secure both sides – do not
over-tighten.
7.
If seismic restraint is
required, attach the
suspension cabel to sheet-
metal tab on the side speaker.
5.
Thread signal wire through
conduit cover plate. Connect
signal wire to 4-pin Euroblock
plug. Tighten unused terminal
screws. Use inside positive
and negative inputs for either
voice coil or distributed
systems. For daisy chaining,
use outside positive and
negative terminals. Euroblock
must be plugged in for dasiy
chain to function.
6.
Insert the Euroblock plug
into the Euroblock jack on
side panel of speaker and
replace conduit cover plate.
For UL-compliant installations
strain relief (not supplied)
may be inserted into hole
in conduit cover plate.